при проектировании камеры прессован

при проектировании камеры прессования, длина камеры рассчитана с учетом процента за-полнения не менее 50% (при заполнении камеры менее 50% требуется согласование с Поку-пателем);

Results (English) 1:

in the design of the baling chamber, the length of the chamber are inclusive percent over-complements at least 50% (when filling the chamber less than 50% is required coordination with Poku-Patel);

Results (English) 2:

When designing a press chamber, the length of the camera is calculated with a percentage of at least 50% (when filling the camera less than 50% requires coordination with the Poku-Patel);

Results (English) 3:

When designing the molding chamber, the length of the chamber is calculated as a percentage of more than 50%)（