После соглосования с супервайзором

После соглосования с супервайзором компании НСПОС Ивановым ,мы начали тестовое использование испарителей на лагунах номер 4А; 4B; 4D при этом выяснилось:

• Для включения насоса в работу необходимо предварительно в ручную заполнить водой шланг подачи воды в насос, что занимает время (as per manual the suction pipe should be the same diameter as the pump suction inlet. When the piping is larger than the pump diameter, self-suction ability is decreased and self-priming impossible).
• На второй день эксплуатации выяснилось, что насосы на двух испарителях № 4D и 4А автоматически отключаются после включения (предположительно - датчик потока воды – дает команду об отключение).

Results (English) 1:

After soglosovaniâ with NSPOS Ivanov's supervisor, we have started to test the use of vaporizers lagoon room 4A; 4B; 4 d with it:

• To enable the pump to work, you must manually fill in the water supply hose to the water pump that takes time (as per the manual, the suction pipe should be the same diameter as the pump suction inlet. When the piping is larger than the pump diameter, self-suction ability is decreased and self-priming impossible).
• on the second day of the operation revealed that pumps on two evaporators No. 4 and 4A are automatically disabled after switching on (presumably water-flow sensor gives a command to deactivate).

Results (English) 2:

After soglosovanie with supervisor of NSPOS Ivanov, we started to test the use of evaporators lagoons Room 4A; 4B; 4D, this turned out:

• To start the pump in operation, you must first manually fill water supply hose to the pump that takes time (as per manual the suction pipe should be the same diameter as the pump suction inlet. When the piping is larger than the pump diameter, self -suction ability is decreased and self-priming impossible).
• On the second day of operation revealed that the pumps on two evaporators № 4D and 4A are automatically turned off after the (presumably - the water flow sensor - gives a command on shutdown).

Results (English) 3:

After approval releases with суперваизором company НСПОС Ivanov ,we started a test using the evaporators at the lagoon number 4A; 4B; 4D when this was found:

- To enable the pump to work must be pre-filled with water in the manual water supply hose to the pump, which takes time (as per manual the suction pipe should be the same diameter as the pump suction inlet. When the piping is due than the pump diameter,Self-suction аbility is deсreаsed and self-AP priming impossible) .
- on the second day of operation revealedThat the pumps at two may 4D, and 4A are turned off automatically after the (allegedly - the sensor water flow - gives the command to disable) .